Grow Tube Frame Clip
6
Likes
134
Downloads
412
Views
Published on July 29, 2012
Description
Clips to hold the 6.8mm fibreglass rods for the frame of a grow tube.
Instructions
Two types of clips. One has a hole right through, the other only 2/3 through as an end stop.
10-Sep-2012 Spring gales (140km gusts) managed to shatter one of my clips. I had printed in PLA with 20% fill. So more infill or a tougher material may be needed for the top clips (with the hole right through).
But only one clip out of 32 (3 grow tubes) broke, so they must be fairly tough already.
10-Sep-2012 Spring gales (140km gusts) managed to shatter one of my clips. I had printed in PLA with 20% fill. So more infill or a tougher material may be needed for the top clips (with the hole right through).
But only one clip out of 32 (3 grow tubes) broke, so they must be fairly tough already.
License
Grow Tube Frame Clip by Inquisitor is licensed under the Attribution - Share Alike - Creative Commons license.
More from Inquisitor
More from Outdoor & Garden
You must be logged in to post a comment.