Extruder barrel cooling duct (40mm)
3
Likes
221
Downloads
581
Views
Published on July 31, 2012
Description
A cooling duct to cool J-Head barrel, designed for mounting a 40mm fan in front of the x-carriage.
Instructions
It just cool the barrel, not the parts.
It is to be mounted under the carriage and above the heater block. The fan is to be mounted on the front side.
This is designed for my repstrap so it might not fits on Mendel. YMMV.
Two mounting holes are 19.6mm apart, and expected to be threaded to M3.
The duct is 18mm thick, ~38mm wide.
It is to be mounted under the carriage and above the heater block. The fan is to be mounted on the front side.
This is designed for my repstrap so it might not fits on Mendel. YMMV.
Two mounting holes are 19.6mm apart, and expected to be threaded to M3.
The duct is 18mm thick, ~38mm wide.
License
Extruder barrel cooling duct (40mm) by sam0737 is licensed under the Attribution - Share Alike - Creative Commons license.
More from sam0737
More from 3D Printer Accessories
You must be logged in to post a comment.