Ventaglio
72
Likes
804
Downloads
1070
Views
Published on August 2, 2012
This thing was Featured on August 2, 2012
Description
Too hot outside?
Here a simple ventaglio (manual fan) ready to be printed and easy to customize with letters, logo or random design, i let flat without decoration for this purpose.
Any improvement is well accepted ;)
Here a simple ventaglio (manual fan) ready to be printed and easy to customize with letters, logo or random design, i let flat without decoration for this purpose.
Any improvement is well accepted ;)
Instructions
# Print List:
- 12 x ventaglio.stl (20cm long and 2mm height) printed with infill 10, - layer 0.27, feedrate 80, travel 150 and temperature 240.
- 1 x ring.stl same settings as before
- 1 x pin.stl printed at feedrate 30, travel 30 and temp 220
- 1 x pin_cover.stl printed at feedrate 30, travel 30 and temp 220
# Unprintable material:
small piece of ribbon 3-4 mm height and 50cm long
# Optional:
Strong Glue
# Special instruction:
Checkout the image for connect the ribbon. Glue the pin and pin cover togheter at the end.
Any improvement is well accepted ;)
- 12 x ventaglio.stl (20cm long and 2mm height) printed with infill 10, - layer 0.27, feedrate 80, travel 150 and temperature 240.
- 1 x ring.stl same settings as before
- 1 x pin.stl printed at feedrate 30, travel 30 and temp 220
- 1 x pin_cover.stl printed at feedrate 30, travel 30 and temp 220
# Unprintable material:
small piece of ribbon 3-4 mm height and 50cm long
# Optional:
Strong Glue
# Special instruction:
Checkout the image for connect the ribbon. Glue the pin and pin cover togheter at the end.
Any improvement is well accepted ;)
You must be logged in to post a comment.
License
Nice! I have been designing a fan, but I hadn't figured out how the blades attached at the base, and now I have yours to use as an example!
One question - what is the wire for? Looking at the photo, it looks like the pin goes through the ring, then the blades (ventaglio), then the ring again, then the pin cover, which is glued on. Then the ribbon goes through the blades, and is tied down to the top and bottom blades. What am I missing
?
Wrong translation wire--
&
gt;ribbon, fixed now, sorry for that :-[