Bowden Clamp for Ultimaker Hot end v2
8
Likes
307
Downloads
1520
Views
Published on October 11, 2012
Derived from
Bowden Clamp for Ultimaker (Heater End)
by owen
Description
Adaptation of great Bowden Clamp by Owen for the Ultimaker hot end V2.
4 12mm washer is required to distribute the clamping force from the bolts.
2 slots are provided below to place the nuts to hold the electronic.
4 12mm washer is required to distribute the clamping force from the bolts.
2 slots are provided below to place the nuts to hold the electronic.
Instructions
No instructions provided.
License
Bowden Clamp for Ultimaker Hot end v2 by hugokernel is licensed under the Attribution - Share Alike - Creative Commons license.
More from hugokernel
More from 3D Printer Accessories
i need to make a double bowden layout.
because i have a dual ultimaker