Stone Celtic Knot
4
Likes
134
Downloads
393
Views
Published on August 1, 2012
Description
This STL file was made by scanning a stone celtic knot paper weight. I made it hollow and cut it in two so I could print two halves then glue together.
Instructions
Made on an Orca 0.42 from Mendelparts using white 1.75mm PLA from Faberdashery at 0.35mm nozzle diameter.
Software used was Sli3er and Pronterface.
If anybody has any suggestions on how I could improve my sidewall quality then I'd be very much appreciative.
Software used was Sli3er and Pronterface.
If anybody has any suggestions on how I could improve my sidewall quality then I'd be very much appreciative.
License
Stone Celtic Knot by magicmodel is licensed under the Attribution - Share Alike - Creative Commons license.
More from Sculptures
You must be logged in to post a comment.