by n8fq, published
This is a little tool we use at the shop to defeat the interlocks on our SLA machines while we are doing all-too-frequent maintenance on the laser and mirrors. Yes, we use goggles - we're not <i>that</i> stupid!
This model is actually my first attempt at CAD. I decided to try OpenSCAD rather than a more traditional tool because I'm much better at coding than I am at drawing! The part is based on measurements I took of an existing part. We only had one, and it seemed like it'd be a good idea to make a few more...
Liked Byview all
Give a Shout Out
Important note: this part is measured in <b>inches</b> - convert if needed.