Alternative gauge holder for mendelmax
4
Likes
276
Downloads
662
Views
Published on August 3, 2012
Derived from
Leveling helper for LM10UU setup
by blddk
Description
Derivative made for mendelmax and dial gauge with a .37" or 9.5mm shaft. Removed holes to secure shaft and made press fit.
Instructions
Derivative made for mendelmax and dial gauge with a .37" or 9.5mm shaft. Removed holes to secure shaft and made press fit.
Included the 123D file for editing if need be.
1. Print
2. Test fit gauge. Sand/File as necessary.
3. Utilize to level bed.
*Update* After further testing I have revised the sizing to better fit between the X rails and made it a bit thicker to alleviate any top heaviness that occurs.
Included the 123D file for editing if need be.
1. Print
2. Test fit gauge. Sand/File as necessary.
3. Utilize to level bed.
*Update* After further testing I have revised the sizing to better fit between the X rails and made it a bit thicker to alleviate any top heaviness that occurs.
You must be logged in to post a comment.
License
Alternative gauge holder for mendelmax by guycaico2 is licensed under the Attribution - Share Alike - Creative Commons license.
More from guycaico2
More from 3D Printer Parts
This is exactly what I was looking for. Thank you very much.