Raspberry Pi LED Extension
13
Likes
217
Downloads
2189
Views
Published on August 10, 2012
This thing was Featured on August 10, 2012
Derived from
Raspberry Pi case
by HansH
Description
I drilled 3 holes in the top of the case and glued transparent PLA filament pieces in these holes. Now I can see if the raspberry has power, if a networkable is attached and the flickering if there are TX/RX activities.
If you want to do it perfect you have to grind the PLA wire a little bit smaller and put 4 pieces in.
Achim
If you want to do it perfect you have to grind the PLA wire a little bit smaller and put 4 pieces in.
Achim
Instructions
No instructions provided.
License
Raspberry Pi LED Extension by jsturm is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from jsturm
This is neat and I'm glad it works. I thought about this but I don't have any transparent material. One more reason I need to place an order.