Rostock Feet
2
Likes
167
Downloads
1013
Views
Published on August 4, 2012
Description
I made these feet for my Rostock printer because I had an LCD interface that put the height of the Arduino / Ramps boards taller than the motor ends. I screwed them into the M4 holes on the bottom of the motor mounts and then added a felt pad to the bottoms.
Instructions
Print six of these (or three if you want). Use M4 screws to screw them into the holes on the bottom of the motor mounts. For extra cushion I added felt pads to cover the screw ends.
You must be logged in to post a comment.
License
More from jamesarm97
More from 3D Printer Parts
Nice! But, you did not show pictures of your Rostock printer. Nice colors....
Sorry. I was trying to get a closeup of the feet. I posted a photo on the I built one section of the Rostock printer page.
Ooops, I forgot to ask. Is it printing and how well? I am also building one.