Castle Greyskull
18
Likes
170
Downloads
625
Views
Published on August 5, 2012
Description
Castle Greyskull
I have the power!!!!!
I have the power!!!!!
Instructions
test printed 2 shells 0% infill
the small prints (on the laptop and on replicator)
big print was
3 shells 0 infill .27 layer height
a few small top of model holes at these settings
picture with the cat shows big print
(also a pic on replicator)
the small prints (on the laptop and on replicator)
big print was
3 shells 0 infill .27 layer height
a few small top of model holes at these settings
picture with the cat shows big print
(also a pic on replicator)
You must be logged in to post a comment.
License
Castle Greyskull by cerberus333 is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from cerberus333
More from Buildings & Structures
Small side note...
DONT enable more than 2 threads in slic3r 0.8.4 advanced tab doing this stl !
Mine crashed multiple times before I realized I needed to change it back to "2"
Thanks,
I use replicatorG so I am not aware of the issues some of my models
might have with other printer/software configurations.
ReplicatorG does complain (errors in the slicing) but I am able to get it to complete and make a print.
I use mostly the default settings.
I do use multiple shells on most of my prints.