Wolverine Claws in plastic
by chefmaki, published
now in extruded plastic form.
print in white to give you that Bone claw look
Recent Commentsview all
upgrade your copy of sli3er or try a different gcode generator software, a couple of people using sli3er reporting problems with one of my other models as well.. but they said it fixed after they updated to the latest version..
I get this error from Sli3er?
=> Processing triangulated mesh
Warning: The input file is not manifold. You might want to check the resulting gcode before printing.
The model has overlapping or self-intersecting facets. I tried to repair it, however you might want to check the results or repair the input file and retry.
No layers were detected. You might want to repair your STL file and retry.
Liked Byview all
Give a Shout Out
Print 3 of the Claws and one of the claws handles for each hand. (6 claws + 2 handles for a set)
No support is needed.
you will need to cut(or dremel) away the support wall I put in the handle slots or print the flat bottom handle if you'd rather not bother with that.
The fixed file was run through netfab.
You must be logged in to post a comment.