Nerf Nitron Wall Hanger
1
Likes
212
Downloads
583
Views
Published on August 10, 2012
Description
This is a custom wall hanger for a Nerf Nitron Disc Blaster. I have put two of them on the wall in my boys' room to help them keep it nice and tidy.
Instructions
1) Print it. I printed mine on my TangiBot (Replicator Clone) with the following settings:
- Accelerated speeds
- 30% fill
- .27mm Layer
- 1 skin
- No scaling
IMPORTANT: If you use the s3g file I uploaded be sure to turn acceleration on before you attempt to print this. The s3g file was generated using accelerated speeds.
2) Secure two drywall anchors in the wall and then screw the wall hanger in place.
3) Now your kids' room magically stays clean ;-)
- Accelerated speeds
- 30% fill
- .27mm Layer
- 1 skin
- No scaling
IMPORTANT: If you use the s3g file I uploaded be sure to turn acceleration on before you attempt to print this. The s3g file was generated using accelerated speeds.
2) Secure two drywall anchors in the wall and then screw the wall hanger in place.
3) Now your kids' room magically stays clean ;-)
License
Nerf Nitron Wall Hanger by MattStrong is licensed under the Attribution - Share Alike - Creative Commons license.
More from MattStrong
More from Organization
You must be logged in to post a comment.