Weapon - Victorian Knuckle Sliced to Print
6
Likes
291
Downloads
702
Views
Published on August 10, 2012
Derived from
Weapon - Victorian Knuckle
by Aliceffekt
Description
I liked this thing very much but my attempts to print it with support were far from desirous. So I sliced it in half to print without support.
Instructions
Print both halves glue together. It's a nice decorative piece or paper weight.
I printed the first half with 0 shells and it came out with voids. The second half I printed with 2 shells and it still had voids so I'm not sure what is going on. However, when both halves are glued together they seem fairly strong for a paper weight.
I printed the first half with 0 shells and it came out with voids. The second half I printed with 2 shells and it still had voids so I'm not sure what is going on. However, when both halves are glued together they seem fairly strong for a paper weight.
You must be logged in to post a comment.
License
Weapon - Victorian Knuckle Sliced to Print by MacGyver is licensed under the Attribution - Creative Commons license.
More from MacGyver
More from Accessories
I like the artistry
not the application!
I thought they were cool looking too. Makes a nice decorative paper weight. My fingers are actually too large to fit in them.