Loading

Intex K2 Inflatable Kayak Paddle Clip

by kojo-jojo, published

Intex K2 Inflatable Kayak Paddle Clip by kojo-jojo Aug 13, 2012

Thing Info

2739Views 411Downloads Found in Sport & Outdoors
Report Thing

Summary

Paddle clip that clips onto the sides of your Intex K2 Inflatable Kayak so that you can clip your Paddles down.

Instructions

Print and clip onto Kayak.

Print 4 (2 for each side) for maximum stability and to hold yours and your kayaking partner's paddles (K2 is a two man kayak)

Not sure if this will work on any other kayaks or not as it was designed exclusively for the Intex Challenger K2. Could possible work with the K1.

More from Sport & Outdoors

view more

Thing Info

2739Views 411Downloads Found in Sport & Outdoors
Report Thing

Liked By

View All

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

All Apps

This extension connects Thingiverse with Makeprintable, a cloud-based mesh repair service that analyzes, validates and repairs most common mesh errors that can occur when preparing a 3D design file...

App Info Launch App

Nunca he impreso, por lo que no tengo una imagen. Hay una llanta que se infla, creo que diseñado para pinzar sobre ese borde. Espero que esto ayude!

y la llanta inflada se sentaría en el agujero grande en la parte. la pequeña clavija redonda en la parte inferior fue diseñada para sentarse dentro de la k1 y presionar contra el interior pared.

I have never printed one, so I do not have a picture. There is a rim that inflates, I believe that I designed it to pinch over that rim. and the inflated rim would sit inside the large hole in the part. the small round peg at the bottom was designed to sit inside the k1 and press up against the inside wall. hope this helps!

Hola Kojo, tendrás una foto para ver como se fija al kayak? yo tengo un k1. Saludos y Gracias por el aporte.

Top