Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Rostock belt spreader with endstop
11
Likes
359
Downloads
1169
Views
Published on August 16, 2012
Derived from
Idler end for Rostock
by Johann
Description
Allows you to use a smaller gear on the stepper motor.
Instructions
No instructions provided.
You must be logged in to post a comment.
Collections
Rostock parts
by sheepdog43
Printer parts
by mark314
The Ultimate Rostock Printer Thing Collection
by EclecticAngler
License
Rostock belt spreader with endstop by lepko is licensed under the Attribution - Share Alike - Creative Commons license.
More from lepko
More from 3D Printer Parts
Why did you need to spread the belt?
I was thinking/hoping that the distance between the idler and gear pulley would be enough that their differences in diameter would not matter.
*DONT_KNOW*
Non-parallel belts can cause a small non-linearity when the carriage is moving at the bottom. With this small difference may be even less than the accuracy of motion of the entire system. But ... printer looks so much nicer when the belts are parallel. :)