Micro-extruder fan shroud
6
Likes
148
Downloads
593
Views
Published on August 14, 2012
Description
This 40mm fan shroud attaches directly to the Ultibots micro-extruder heat sink with Akasa thermal tape.
Alibre PE source files included.
MendelMax 1.5+ kits and printed parts are available for purchase at ultibots.com.
Alibre PE source files included.
MendelMax 1.5+ kits and printed parts are available for purchase at ultibots.com.
Instructions
Use Akasa heat tape to affix heat sink to eMinebea motor.
Cut out tape to match heat sink slots.
Use left over cut outs to affix shroud to heat sink.
Cut out tape to match heat sink slots.
Use left over cut outs to affix shroud to heat sink.
License
Micro-extruder fan shroud by Ultibots is licensed under the Attribution - Share Alike - Creative Commons license.
More from Ultibots
More from 3D Printer Parts
You must be logged in to post a comment.