Canada Opener
11
Likes
529
Downloads
1065
Views
Published on August 15, 2012
Description
Modded Tapered Pocket Coin-Op for Canadian use.
Based on thing 12348
Inspired by thing 28349
Maple Leaf borrowed from thing 24830
Based on thing 12348
Inspired by thing 28349
Maple Leaf borrowed from thing 24830
Instructions
Dualstrusion, left is red, right is white. I used the default settings for the Replicator.
US pennies are accepted.
The "original" Sketchup file is not scaled properly. Only after I'd separeated the pieces did I figure out it was gigantic.
If rotated 90 degrees (about Z) clockwise getting the penny in would be easier. I'm not sure if that would screw up the dualstrusion merge or not, though.
US pennies are accepted.
The "original" Sketchup file is not scaled properly. Only after I'd separeated the pieces did I figure out it was gigantic.
If rotated 90 degrees (about Z) clockwise getting the penny in would be easier. I'm not sure if that would screw up the dualstrusion merge or not, though.
License
Canada Opener by s_p_e_x is licensed under the Attribution - Share Alike - Creative Commons license.
More from s_p_e_x
More from Hand Tools
You must be logged in to post a comment.