Makergear X-Carriage V4 modified for lm8uu
6
Likes
159
Downloads
872
Views
Published on August 16, 2012
Description
I really liked this X-Carriage but I hate bronze bushings. Extended the depth of the hole to accomidate lm8uu.
Instructions
Put an lm8uu on each rod then add the carriage and add another set of lm8uu. Make sure the lm8uu sits inside the hole and then use a heatgun and a set of pliars to gently press the plastic to trap the lm8uu inside for each corner.
You must be logged in to post a comment.
License
Makergear X-Carriage V4 modified for lm8uu by cake is licensed under the Attribution - Share Alike - Creative Commons license.
More from cake
More from 3D Printer Parts
Just an FYI, it will still work with the bronze bearings as well :)