Replicator Hood fume extractor
14
Likes
140
Downloads
855
Views
Published on August 18, 2012
Derived from
Replicator 3mm hood and cover
by drandolph
Description
People were asking for a way to vent or manage fumes on the Replicator hood. thingiverse.com/thing:23386
This mounts with a 40mm fan and fits a 3" dryer tube.
This mounts with a 40mm fan and fits a 3" dryer tube.
Instructions
All you need is a 40mm fan and 4 M3 bolts. if you use a 10mm fan then use 20mm bolts and 30mm bolts for a 20mm fan. The holes in the print will self tap. You can pick up a 3" dryer vent and hose clamp from your local hardware store and your done.
I also put in a fan guard inside so without a hose you can use this as a fume extractor by going to your local pet supply store and getting some activated filter carbon and some loss filter material. Just put in some filter up against the fan guard, fill with carbon and then top off with more filter.
I also put in a fan guard inside so without a hose you can use this as a fume extractor by going to your local pet supply store and getting some activated filter carbon and some loss filter material. Just put in some filter up against the fan guard, fill with carbon and then top off with more filter.
License
Replicator Hood fume extractor by drandolph is licensed under the Attribution - Creative Commons license.
More from drandolph
More from 3D Printer Accessories
You must be logged in to post a comment.