Spool Hub
0
Likes
51
Downloads
188
Views
Published on August 20, 2012
Description
I think you are required to design your own spool hub if you have a 3d printer, this one is mine.
It fits 8mm rod; an old mendel shaped desk inbox in my case.
Its a 10 lb roll of filament, so its a wide holed center on the plastic rings on the spool.
The machine can't pull it, you must pre slack before you print.
It fits 8mm rod; an old mendel shaped desk inbox in my case.
Its a 10 lb roll of filament, so its a wide holed center on the plastic rings on the spool.
The machine can't pull it, you must pre slack before you print.
Instructions
No instructions provided.
License
More from kenwshmt
More from 3D Printer Accessories
You must be logged in to post a comment.