Grill for 50 mm fan
by egil, published
This nicely designed piece by Sterling prints much better upside down. The original either leaves a coarse inside with lots of strings to clean up, or needs support. The height has been reduced from 5 mm to 3, since the clean print needs less tolerances against the fan blades.
This cover is universal and should fit any standard 50 mm fan with 40 mm hole spacing, not only for the Ultimaker.
Straight forward print.
Liked ByView All
Give a Shout Out
Grill for 50 mm fan by egil is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure egil would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).