Fan grill for standard Ultimaker
10
Likes
142
Downloads
691
Views
Published on August 21, 2012
Derived from
Fan Grill for Ultimaker
by Sterling
Description
Based on Sterling's nice design, but truncated so that it fits the fan in the original horizontal mounting position, and without disturbing the Z-axis clearance.
Instructions
Should print nicely with no cleanup and no support needed. Held down by the two separate M3 screws that holds the fan duct - you may need 20 mm long screws, though. The cover is also 2 mm thinner than Sterling's version - the strength should be the same.
(If you did not make your own fan duct yet, consider doing so, the standard item has a tendency of interfering with your print after a while. The design in thingiverse.com/thing:25611 is a good example.)
(If you did not make your own fan duct yet, consider doing so, the standard item has a tendency of interfering with your print after a while. The design in thingiverse.com/thing:25611 is a good example.)
License
Fan grill for standard Ultimaker by egil is licensed under the Attribution - Share Alike - Creative Commons license.
More from egil
More from 3D Printer Accessories
You must be logged in to post a comment.