Thingiverse
3D Printing 3D Printer Accessories

RepRapDiscount Smart Controller case for MendelMax

Pacca
1049
Downloads
2829
Views
Published on August 23, 2012

Derived from

Ramps Ultipanel Case (rrd Display)
by Chri

Description

RepRapDiscount Smart Controller case for MendelMax

Cable can be disconnected without opening the case
Large 30mm button
Reset knob (no screwdriver needed)
Hole for brightness potentiometer

Instructions

Put this instead of the top right vertex
Tags
This Thing has no tags.
Report as inappropriate

You must be logged in to post a comment.

docdavies on April 14, 2013 said:

When I tried to make this part it seemed too big for my LCD. The size seems to be 155x68x18 for front. It looks like my LCD set up is consistently 0.85x of the LCD opening and screw down points. I was concerned I had mucked up the scaling. but Using Meshlab it gave me the same measurements as my mic. Have I made a mistake or could I have very different LCD. Got mine as kit from 3D Gadgets the RAMPS 1.4 Ultimate kit.

ta305 on October 2, 2012 said:

looks great, but are you using the 30cm cables? I know about the problem with the 1 meter cables but I'm wondering if there is some way around this.

Ultibots on September 7, 2012 said:

Pacca -

Nice Job... Printed and installed fine.

Brad

Ultibots on September 10, 2012 said:

Pacca -

Correction, I only printed your back and used Chri's front.

Later I printed you front in a new color but it failed.

Please invert the Z axis.

Brad

Pacca on September 7, 2012 said:

Thanks, now i can remove the WIP!

Add some pictures if you can :)

Collections

View all
RepRap
by tmenet
RepRap parts
by Pacca
Things to Make
by nimco123

Remixes

Made

View all
_DSC1287.JPG

Liked by

View all

License

RepRapDiscount Smart Controller case for MendelMax by Pacca is licensed under the Attribution - Creative Commons license.

More from Pacca

More from 3D Printer Accessories

⇪