unhobbled Bolt
0
Likes
112
Downloads
486
Views
Published on August 25, 2012
Derived from
ABS-Lock Nuts (8mm)
by wulfdesign
Description
Intended for modeling.
55 mm long.
the shaft is unthreaded, but machine variance will still probably make the threads on a 8mm nut still catch.
This is useless for anything but reference and model making.
If you have a hobbling rig, maybe use them for practice.
55 mm long.
the shaft is unthreaded, but machine variance will still probably make the threads on a 8mm nut still catch.
This is useless for anything but reference and model making.
If you have a hobbling rig, maybe use them for practice.
Instructions
This was tricky to get to print right.
start out hot, then set the extruder temp down to barely extrudable after its a few rows up the shaft.
If you don't it will be a blob of uncooling plastic about an inch up.
It took a fan.
Running it this cool will make a good print, but it won't have any tensile strentgh and will easily snap.
start out hot, then set the extruder temp down to barely extrudable after its a few rows up the shaft.
If you don't it will be a blob of uncooling plastic about an inch up.
It took a fan.
Running it this cool will make a good print, but it won't have any tensile strentgh and will easily snap.
License
More from kenwshmt
More from 3D Printer Parts
You must be logged in to post a comment.