Spool Roller 2
19
Likes
294
Downloads
1132
Views
Published on August 26, 2012
Derived from
Printable Spool Roller
by CidVilas
Description
Derivative slightly adapted for reprapworld 1kg spool (don't know if from repraper or another asian manufacturer).
Which is 160mm diam. 90mm large (side to side, external)
Redrawn in Sketchup for 624 bearings and use few plastic (total volume 17,19 cm³) :)
--
added one for a small spool 205mm diam. 45mm side to side internally (or 53ext.) I got from mendel-parts
--
and another for 55mm int. side to side (salvaged from stratasys dimension cartridges)
Which is 160mm diam. 90mm large (side to side, external)
Redrawn in Sketchup for 624 bearings and use few plastic (total volume 17,19 cm³) :)
--
added one for a small spool 205mm diam. 45mm side to side internally (or 53ext.) I got from mendel-parts
--
and another for 55mm int. side to side (salvaged from stratasys dimension cartridges)
Instructions
Add :
4* 624 bearings
4* M4x20 bolts
8* M4 Washers (probably fine without)
4* 624 bearings
4* M4x20 bolts
8* M4 Washers (probably fine without)
You must be logged in to post a comment.
License
Spool Roller 2 by watsdesign is licensed under the Attribution - Share Alike - Creative Commons license.
More from watsdesign
More from 3D Printer Accessories
Curious question. Do you find that when the spool gets lighter any problems occur? I don't have a specific concern, just wondering. Spool being pulled off the rollers or line getting between the spool and base...etc? I am printing mine now and have ordered the bearings.
Yes, at the end of the roll the spool is so light that it is easily lifted by the extruder, but it only happen with the small 1kg kind of spools I have, the 2.3kg having a bigger radius the springiness of the filament is less problematic