Morgan Horse
13
Likes
494
Downloads
1420
Views
Published on August 27, 2012
Description
Morgan Horse
Modeled in sculptris
and
Truespace 5
The original model gave me problems printing.
I am leaving it up for those who want to use it for derivatives etc.
the split model printed ok for me.
it has thicker legs and some other minor changes from the original.
I must say the split model looks really creepy to me!
Modeled in sculptris
and
Truespace 5
The original model gave me problems printing.
I am leaving it up for those who want to use it for derivatives etc.
the split model printed ok for me.
it has thicker legs and some other minor changes from the original.
I must say the split model looks really creepy to me!
Instructions
needs support
The original had problems printing.
I have posted a split model
this still uses support (much less of it!), but does successfully print
I used 3 shells and 10% fill
I posted a pic of the failed print of full model
(tail exploded, hoof detached)
The original had problems printing.
I have posted a split model
this still uses support (much less of it!), but does successfully print
I used 3 shells and 10% fill
I posted a pic of the failed print of full model
(tail exploded, hoof detached)
You must be logged in to post a comment.
Busybotz
on
August 27, 2012
said:
That's a challenging print. I was wondering about the over hang on the head when I first saw you post the model.
cerberus333
on
August 27, 2012
said:
i had a few problems with it
the rear left leg seperated I will thicken this in hope of fixing that
the tail exploded into a ball of yarn
I think i will bite the bullet and model in a rod for support
which i will cut off after the print is done
finally i had a nozzel clog which stopped the rest of the print
I will have to do a extruder cleanout as well
License
Morgan Horse by cerberus333 is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from cerberus333
More from Animals
Nice! I used to raise morgans and saddlebreds in Minnesota... morgans are awesome horses!
My wife's sister had a Morgan/mixed with something else
and asked me to make a horse print for her.
hopefully I am not too far off on this model.