iPhone 4 Tripod Manfrotto Quick Release
8
Likes
103
Downloads
648
Views
Published on August 28, 2012
Derived from
iPhone Quick Release Targus
by BSchuler
Description
I made the angled bevels match the same angle as my tripod head, I made it considerably thinner for faster/cheaper prints. Resized to fit perfectly in my Manfrotto 700RC2 fluid head.
I was at first a bit skeptical of this design; I was concerned that the iPhone could slip out, but it is able to firmly grasp the iPhone even upside-down (see photo).
I was at first a bit skeptical of this design; I was concerned that the iPhone could slip out, but it is able to firmly grasp the iPhone even upside-down (see photo).
Instructions
Print!
I printed at 150mm/s, 50% infill, 0.2mm layers with 0.1mm skin.
For plastic shrinkage I have my scale set to 103% (thats what I use for all my PLA so far) and it came out the perfect size for my iPhone 4 and Manfrotto.
I printed at 150mm/s, 50% infill, 0.2mm layers with 0.1mm skin.
For plastic shrinkage I have my scale set to 103% (thats what I use for all my PLA so far) and it came out the perfect size for my iPhone 4 and Manfrotto.
License
iPhone 4 Tripod Manfrotto Quick Release by 3DTOPO is licensed under the Attribution - Share Alike - Creative Commons license.
You must be logged in to post a comment.