Festo Actuator Dust Cap
0
Likes
68
Downloads
391
Views
Published on August 29, 2012
Description
This is a dust cap for a DFM12 Festo pneumatic actuator.
If installed as seen in the pictures there is allot of dust that accumulates inside the guide rods. Eventually the brass bushings inside go bad. So this is an easy way to address the problem.
If installed as seen in the pictures there is allot of dust that accumulates inside the guide rods. Eventually the brass bushings inside go bad. So this is an easy way to address the problem.
Instructions
They were printed at 0.1mm layer, 2 perimeters and 100% infill. The holes are a bit tight and will need a drill to make the clearance for the M4. But all in all they look great even has the Festo blue and each takes about 2 hours to print.
License
Festo Actuator Dust Cap by DanLuc is licensed under the Attribution - Share Alike - Creative Commons license.
More from DanLuc
You must be logged in to post a comment.