X-ends for holding 20x20 extrusion nuts/lm8uus
7
Likes
234
Downloads
640
Views
Published on August 30, 2012
Description
As seen here:
youtube.com/watch?v=7Cn1s9_PII0
These ends use LM8uus.
These x-ends are compatible with a simple Z-Nut or dual Z-nut with spring pair - should fit M8 or similar, I'm using it on acme 1/4" rods in the video.
These x-ends don't hold x-rods, they hold a single 20x20 extrusion.
both ends have an integrated bolt holder meant to interface with a z-endstop held in the lower part from thingiverse.com/thing:28425
By the way these are intended for 605zz idler bearings, you'll have to enlarge the hole either before or after printing if you intend to use 608zzs.
youtube.com/watch?v=7Cn1s9_PII0
These ends use LM8uus.
These x-ends are compatible with a simple Z-Nut or dual Z-nut with spring pair - should fit M8 or similar, I'm using it on acme 1/4" rods in the video.
These x-ends don't hold x-rods, they hold a single 20x20 extrusion.
both ends have an integrated bolt holder meant to interface with a z-endstop held in the lower part from thingiverse.com/thing:28425
By the way these are intended for 605zz idler bearings, you'll have to enlarge the hole either before or after printing if you intend to use 608zzs.
Instructions
No instructions provided.
License
X-ends for holding 20x20 extrusion nuts/lm8uus by Simonious is licensed under the Attribution - Creative Commons license.
More from Simonious
More from 3D Printer Parts
You must be logged in to post a comment.