Multirotor / Multicopter motor mount
16
Likes
736
Downloads
1707
Views
Published on September 2, 2012
Description
simple mount for brushless motor for use in multirotor aircraft.
Instructions
I used #4-40 hardware for the motor and bar mounts.
Shown attached to ~16mm aluminum towel bar
OpenSCAD included if you need to tweak to fit your dimensions
See thingiverse.com/thing:28038 for strut
See thingiverse.com/thing:29624 for frame
Shown attached to ~16mm aluminum towel bar
OpenSCAD included if you need to tweak to fit your dimensions
See thingiverse.com/thing:28038 for strut
See thingiverse.com/thing:29624 for frame
You must be logged in to post a comment.
License
Multirotor / Multicopter motor mount by TheCase is licensed under the Attribution - Creative Commons license.
More from TheCase
More from R/C Vehicles
The quad motor mount "top piece" is unable to slice correctly in Slic3r.
Hrm. Have you tried sending it through netfabb? http://cloud.netfabb.com/