Wizard with orb
5
Likes
92
Downloads
435
Views
Published on September 3, 2012
Description
Wizard with a orb says it all
Modeled in Sculptris and truespace 5
Modeled in Sculptris and truespace 5
Instructions
I test printed with 2 shells 0% infill
the top of the orb has a few holes at these settings
the area under the arms is a little rough (steeper than 45 degrees)
not perfect but feel free to remodel, change print settings etc.
the top of the orb has a few holes at these settings
the area under the arms is a little rough (steeper than 45 degrees)
not perfect but feel free to remodel, change print settings etc.
License
Wizard with orb by cerberus333 is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from cerberus333
More from People
You must be logged in to post a comment.