Raspberry Pi Tower
8
Likes
216
Downloads
3034
Views
Published on September 7, 2012
Derived from
Raspberry Pi Enclosure
by builttospec
Description
A nice way to stack 2 or more Rpi's.
Based on the Built to spec Rpi case.
(slightly larger bolts)
Based on the Built to spec Rpi case.
(slightly larger bolts)
Instructions
All parts made from 3mm acrylic,
The dxf file is for a 5 high tower and 1 case.
obviously you make as many as you need and edit the tower drawing!
the cases are bolted to the stand with 8mm bolts.
The heads of the case bolts poke through the stand so you need to check the head size of your bolts and make changes to the drawing if needed.
I recommend making a case for and checking your bolts work
I used 3.5 x 20mm slot heads for the cases,
the Silver bars in mine at the bottom is there purely for looks!
The dxf file is for a 5 high tower and 1 case.
obviously you make as many as you need and edit the tower drawing!
the cases are bolted to the stand with 8mm bolts.
The heads of the case bolts poke through the stand so you need to check the head size of your bolts and make changes to the drawing if needed.
I recommend making a case for and checking your bolts work
I used 3.5 x 20mm slot heads for the cases,
the Silver bars in mine at the bottom is there purely for looks!
You must be logged in to post a comment.
License
More from urbanledge
More from Electronics
Nice work. Where u use all those Pi's for?
Yo,
I made the case for someone else.
Not sure what hes up too!
He did say something about a super Pi computer or something!