Telecaster Pickguard
9
Likes
362
Downloads
2234
Views
Published on September 12, 2012
This thing was Featured on September 17, 2012
Description
8 Hole Pickguard for Fender Telecaster w/neck pick up mounting holes.
This was so close to fitting on my MendelMax 1.5, but ultimately I had to split it up to be able to print it.
I'm still using my Prusa MK1 PCB heated bed, so if your bed is larger than that, you should be good with the full pickguard.
This was so close to fitting on my MendelMax 1.5, but ultimately I had to split it up to be able to print it.
I'm still using my Prusa MK1 PCB heated bed, so if your bed is larger than that, you should be good with the full pickguard.
Instructions
1. Print Full stl.
or
2. Print TelePGRT
3. Print TelePGLT
4. Glue together
5. Mount on guitar
6. Rock out!
or
2. Print TelePGRT
3. Print TelePGLT
4. Glue together
5. Mount on guitar
6. Rock out!
You must be logged in to post a comment.
License
Telecaster Pickguard by Entropy85 is licensed under the Attribution - Share Alike - Creative Commons license.
The pickguard is just laying on my telecaster in the picture and was not glued together. I think blue is a terrible color for this, but black, white, or natural probably wouldn't look too bad.