Removeable spoolholder for ORCA printer
2
Likes
274
Downloads
906
Views
Published on September 13, 2012
Description
Here are some nice removeable Spoolholders for your great Orca Printer :)
the tip of the lower spoolholer is made a bit longer so you can also put 100mm wide rolls on it , they won`t fall of anymore !
Only for 1,75mm filament !
This is a modification from Mendelparts original spoolholder.
the tip of the lower spoolholer is made a bit longer so you can also put 100mm wide rolls on it , they won`t fall of anymore !
Only for 1,75mm filament !
This is a modification from Mendelparts original spoolholder.
Instructions
Just print them and put them on your printer.
ensure that you printer is well tuned, they fit tight.
should fit PnP on most V40+
For V30 (and some early V40) you need to drill some holes and screws + nuts.
2x M3x10mm + nuts
2x M4x10mm + nuts
the upper part is made for 5mm teflon tube to fit in.
ensure that you printer is well tuned, they fit tight.
should fit PnP on most V40+
For V30 (and some early V40) you need to drill some holes and screws + nuts.
2x M3x10mm + nuts
2x M4x10mm + nuts
the upper part is made for 5mm teflon tube to fit in.
License
Removeable spoolholder for ORCA printer by Chri is licensed under the Attribution - Share Alike - Creative Commons license.
More from Chri
More from 3D Printer Accessories
You must be logged in to post a comment.