DrSpool (for the Replicator)
3
Likes
206
Downloads
853
Views
Published on September 13, 2012
Description
A variable spoolholder for the Makerbot Replicator.
It's made to use with three M3 sunken head screws (15±5 mm) and nuts.
Part A Big is supposed to be for Makerbot filament min. Ø52mm.
Part A small is for other types (variable).
[in v2 the holes are larger]
It's made to use with three M3 sunken head screws (15±5 mm) and nuts.
Part A Big is supposed to be for Makerbot filament min. Ø52mm.
Part A small is for other types (variable).
[in v2 the holes are larger]
Instructions
Arrange the STL files how you like them but rotate them preferably with the flat side on the printbed.
3 perimeter shells
0.25 mm z height
Spool base 100% infill
Part A big and small 30 % infill
Part B 50 % infill
PLA
Full Raft and support
Put in the nuts.
And screw together.
The part B shouldn't be over tightened, it's just a guide.
3 perimeter shells
0.25 mm z height
Spool base 100% infill
Part A big and small 30 % infill
Part B 50 % infill
PLA
Full Raft and support
Put in the nuts.
And screw together.
The part B shouldn't be over tightened, it's just a guide.
License
DrSpool (for the Replicator) by Tentacl3d is licensed under the Attribution - Share Alike - Creative Commons license.
More from Tentacl3d
More from 3D Printer Accessories
You must be logged in to post a comment.