Panelolu case stand with sanguino included !
6
Likes
336
Downloads
1376
Views
Published on September 14, 2012
Description
This is a Stand for the Panelolu LCD ( thingiverse.com/thing:28332 ) which also carries the Sanguino 1.3a board itself.
I designed this because my miniprinter is too small to mount the Board onto it ^^
I designed this because my miniprinter is too small to mount the Board onto it ^^
Instructions
I recommend to change the connectors to one who are straight or bend them to show upwards (except the heater connectors)
but it will also work with the connectors in normal position.
Add two connectors to the 12V rail between the stepper connectors to attach the fans (2x50mm)
Exchange the actual case screws with 40mm one`s
Print both feet, and put them on the Sanguino board.
then push the stand through the LCD-Case screws.
then lift the board a little bit to get the LCD-cable through between the LCD and the board.
Then fix the stand with three additional screws.
but it will also work with the connectors in normal position.
Add two connectors to the 12V rail between the stepper connectors to attach the fans (2x50mm)
Exchange the actual case screws with 40mm one`s
Print both feet, and put them on the Sanguino board.
then push the stand through the LCD-Case screws.
then lift the board a little bit to get the LCD-cable through between the LCD and the board.
Then fix the stand with three additional screws.
License
Panelolu case stand with sanguino included ! by Chri is licensed under the Attribution - Share Alike - Creative Commons license.
More from Chri
More from 3D Printer Accessories
You must be logged in to post a comment.