Ramps 1.4 adaptor for ORCA Printer
0
Likes
178
Downloads
1070
Views
Published on September 14, 2012
Description
This are two small adaptor pieces to put on the Ramps 1.4 board on your Orca printer.
Instructions
Print both pieces with support.
The parts are very tiny, use a small print setting, and ensure that the support is not too strong or it is very difficult to remove afterwards.
Mount both plates with short M3 screws on your printer ans just plug the Ramps 1.4 Kit into the Adapter.
The board itself is not fixed by screws, it holds just by pushing it into the frame.
the board holds very good, it can not fall of by mistake !
The parts are very tiny, use a small print setting, and ensure that the support is not too strong or it is very difficult to remove afterwards.
Mount both plates with short M3 screws on your printer ans just plug the Ramps 1.4 Kit into the Adapter.
The board itself is not fixed by screws, it holds just by pushing it into the frame.
the board holds very good, it can not fall of by mistake !
License
Ramps 1.4 adaptor for ORCA Printer by Chri is licensed under the Attribution - Share Alike - Creative Commons license.
More from Chri
More from 3D Printer Accessories
You must be logged in to post a comment.