Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Arduino Enclosure Lid, Rev1 (mm)
4
Likes
206
Downloads
1031
Views
Published on September 14, 2012
Description
This is the lid for the Arduino Enclosure thing.
When was 3D printed it was necessary to multiply the dimensions x1000 as it was originally CADed up in millimeters and when it was exported to an .stl file the units were changed to meters.
When was 3D printed it was necessary to multiply the dimensions x1000 as it was originally CADed up in millimeters and when it was exported to an .stl file the units were changed to meters.
Instructions
This lid slides into the Arduino Enclosure (see other thing titled: Arduino Enclosure, Rev#).
Note:
When was 3D printed it was necessary to multiply the dimensions x1000 as it was originally CADed up in millimeters and when it was exported to an .stl file the units were changed to meters.
I referenced schematics by johngineer found here:
adafruit.com/blog/2011/02/28/arduino-hole-dimensions-drawing/
and schematics by Wayne and Layne found here:
wayneandlayne.com/blog/2010/12/19/nice-drawings-of-the-arduino-uno-and-mega-2560/
in the design of this thing.
Whim
imaginen4tion.com
Note:
When was 3D printed it was necessary to multiply the dimensions x1000 as it was originally CADed up in millimeters and when it was exported to an .stl file the units were changed to meters.
I referenced schematics by johngineer found here:
adafruit.com/blog/2011/02/28/arduino-hole-dimensions-drawing/
and schematics by Wayne and Layne found here:
wayneandlayne.com/blog/2010/12/19/nice-drawings-of-the-arduino-uno-and-mega-2560/
in the design of this thing.
Whim
imaginen4tion.com
License
Arduino Enclosure Lid, Rev1 (mm) by ImagineN4tion is licensed under the Attribution - Non-Commercial - Share Alike license.
More from ImagineN4tion
More from Electronics
You must be logged in to post a comment.