Manifold LowPoly Firefly Serenety
33
Likes
384
Downloads
2453
Views
Published on September 14, 2012
Derived from
Serene Firebug (Firefly Serenity)
by 7777773
Description
Mal: Fay-yoo? Ah... ah... OK, she won't be winning any beauty contests anytime soon, but she is solid. Ship like this, be with you till the day you die.
Zoe: Because it's a death trap.
Tried using 77777773's low poly firefly for a project and found it riddled with geometry errors. Spent all day fixing them so here's the manifold low-res version.
Zoe: Because it's a death trap.
Tried using 77777773's low poly firefly for a project and found it riddled with geometry errors. Spent all day fixing them so here's the manifold low-res version.
Instructions
No instructions provided.
You must be logged in to post a comment.
laird
on
September 15, 2012
said:
Printed it. Serenity in Glow-in-the-Dark PLA, cool!
That being said, the engines broke off when removing support, which was a bit of a bummer - the 'wings' are very thin. Superglued 'em back on. But you may want to make the 'wings' thicker to hold better.
Printing double-size now!
ZaphodBeeblebrox
on
September 16, 2012
said:
Ten-times size of the high-poly version. I run a Rapman 3.1, with a max build area of about 8 inches cubed. I had to cut it into about twenty segments. The bridge alone took a solid week of printing.
cymon
on
September 15, 2012
said:
Well, I did say it was Fay-yoo.
For my purposes I had to thicken the wings right to the base. Planning on making a firefly ring using the elegant ring base.
Collections
Stuff I Will Make.....If I ever get a MakerBot
by EdgyDevin1234
Things to Make
by visaviz
Rings
by RyanMark
License
Manifold LowPoly Firefly Serenety by cymon is licensed under the Attribution - Share Alike - Creative Commons license.
Some of it is off center...the dome isn't on the same axis as the tail and nose :(