Raspberry Pi Sketchup model to scale
5
Likes
294
Downloads
1362
Views
Published on September 15, 2012
Description
To scale 3D model Sketchup model of the fabulous Rapsberry Pi computer.
Instructions
No instructions provided.
You must be logged in to post a comment.
License
Raspberry Pi Sketchup model to scale by kalooki is licensed under the Attribution - Share Alike - Creative Commons license.
More from Computer
I know there are a few versions of the PI about and this has caused me no end of frustration.
My board, marked E2712RSV1.0B1.1, seems a little different from your model. If I am driving sketch up correctly.
I suspect that the diameter of the video jack is incorrect.
I measure the model at around 6.3 when I think it should be nearer 8.4 mm
This should be the same on all PI versions.
Differences between PI E2712RSV1.0B1.1 and model: -
My network connetor is 13.5mm high
My USB port has a white plas
tic tab extending out at the bottom
The flanges on the power supply connection on my PCB make it 3mm high at the front.
My PCB is a full 1.0 mm wider at 56.1
The pitch of my audio and video connecters is different
Nice model, perhaps add a PI version / model number to it?