Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Cheap-O [SMD]
9
Likes
524
Downloads
2026
Views
Published on September 15, 2012
Derived from
Cheap-O (the sub $2 magnetic endstop)
by hmeyer
Description
This is my version of the Cheap-O hall sensor
Instructions
Print two of the same clamps (depending on if you got 8 or 10mm rods.
Put two M3 bolts through and tighten them around the rod.
Adjust Z height...
Print more! :)
Put two M3 bolts through and tighten them around the rod.
Adjust Z height...
Print more! :)
You must be logged in to post a comment.
License
More from blddk
More from 3D Printer Accessories
Where did you get the PCB?
I ordered them from iTead