40MM Fan duct mount for V4 Makergear X-Carriage
2
Likes
173
Downloads
1251
Views
Published on September 15, 2012
Description
I really liked the way the 40MM fan duct looked but there was no belt clamp mount available for the X-Carriage I used so I designed one. Enjoy!
Instructions
Use this inplace of your belt clamps.
Center groove on the duct is really thin and not very useful due to poor tolerances in the original design. This mount assumes it has broken off on the duct or you are able to remove it.
Center groove on the duct is really thin and not very useful due to poor tolerances in the original design. This mount assumes it has broken off on the duct or you are able to remove it.
You must be logged in to post a comment.
License
40MM Fan duct mount for V4 Makergear X-Carriage by cake is licensed under the Attribution - Share Alike - Creative Commons license.
More from cake
More from 3D Printer Parts
I just posted V3 of the fan duct. It is compact and fits between the bearing holders on a SupaFlat carrier.It also has beefier mounts that should fit nicely with this mount.V3 is at: http://www.thingiverse.com/thi...