PrintRbot nema17 Z endstop box
3
Likes
130
Downloads
1566
Views
Published on September 16, 2012
Derived from
Printrbot X Nema 17 fan mount
by kenwshmt
Description
A Slide on / off nema 17 box with a screw hole for long screws.
This is for lowering your Z end stop for head attachments that go below the current Z end stop.
The longer screw reaches the switch from higher up.
It slides on and off easily at any time.
It has a fan mount on top aimed at the extrusion head, useful for helping cool the extruder motor or as an area cooler. If its put on with the fan on the bed side, it blows down onto the bed.(see derivitive sorce)
Intended for use with these:
PrintRbot laser mount thingiverse.com/thing:30064
PrintRbot engraver mount thingiverse.com/thing:30520
PrintRbot marker mount thingiverse.com/thing:30999
PrintRbot Z end stop extender. thingiverse.com/thing:30590
This is for lowering your Z end stop for head attachments that go below the current Z end stop.
The longer screw reaches the switch from higher up.
It slides on and off easily at any time.
It has a fan mount on top aimed at the extrusion head, useful for helping cool the extruder motor or as an area cooler. If its put on with the fan on the bed side, it blows down onto the bed.(see derivitive sorce)
Intended for use with these:
PrintRbot laser mount thingiverse.com/thing:30064
PrintRbot engraver mount thingiverse.com/thing:30520
PrintRbot marker mount thingiverse.com/thing:30999
PrintRbot Z end stop extender. thingiverse.com/thing:30590
Instructions
No instructions provided.
License
PrintRbot nema17 Z endstop box by kenwshmt is licensed under the Attribution - Creative Commons license.
More from kenwshmt
More from 3D Printer Accessories
You must be logged in to post a comment.