Samsung Galaxy Note camera mount
4
Likes
108
Downloads
1056
Views
Published on September 16, 2012
Description
This is a minimalist mount to attach the Note to a Replicator to take time lapse photos. It makes use of the standard Samsung cover, which otherwise just gets in the way.
Instructions
This probably needs internal support turning on. I didn't and the middle of the clip was a bit stringy. However, it cleaned up ok, so suit yourself.
Trap the phone cover between the mount and the top of the replicator. Tuck the legs between the insets in the cover so they rest against the phone's back, holding it at an angle to get a sort of isometric view of the printing.
Line the camera up to get the shot you want, and off you go.
Trap the phone cover between the mount and the top of the replicator. Tuck the legs between the insets in the cover so they rest against the phone's back, holding it at an angle to get a sort of isometric view of the printing.
Line the camera up to get the shot you want, and off you go.
License
Samsung Galaxy Note camera mount by pintokitkat is licensed under the Attribution - Share Alike - Creative Commons license.
More from pintokitkat
More from 3D Printer Accessories
You must be logged in to post a comment.