Arduino RAMPS 1.4 Prusa Support with fan
11
Likes
120
Downloads
1844
Views
Published on September 17, 2012
Description
This is a support for RAMPS 1.4 and arduino on a Mendel Prusa.
It locates the whole electronics on the upper section of the printer.
It also features the possibility to add a 90mm fan to cool down the stepper drivers as well as a central filament guide.
The original model was printed in ABS with a 0.20mm layer height. Takes about 3h30 to print.
NOTE: The support for the fan has to be treated gently. I will reinforce the columns in a future revision.
It locates the whole electronics on the upper section of the printer.
It also features the possibility to add a 90mm fan to cool down the stepper drivers as well as a central filament guide.
The original model was printed in ABS with a 0.20mm layer height. Takes about 3h30 to print.
NOTE: The support for the fan has to be treated gently. I will reinforce the columns in a future revision.
Instructions
- Rotate model to convenience
- Print
- Install:
Part attaches to the upper threaded rods of the Prusa, no additional hardware required.
- Install:
Part attaches to the upper threaded rods of the Prusa, no additional hardware required.
License
Arduino RAMPS 1.4 Prusa Support with fan by autronix is licensed under the Attribution - Creative Commons license.
More from 3D Printer Accessories
You must be logged in to post a comment.