Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Coin Sorting Trays
52
Likes
1947
Downloads
2751
Views
Published on September 17, 2012
Derived from
Printable Coin Mech 0.2
by IWorkInPixels
Description
Stack Them, and shake them. and your work is done.
Instructions
Object size is 120mm x 120mm x 30mm
45 Degree supports suggested.
Added a OpenSCad File to make your own trays. just open it up set the var and have let it fly!
Stack up the trays from smallest to largest, put the solid tray on the bottom. then shake them.
Trays are labeled for the hole in them not the coin they collect. For example the Dime tray will collect Pennies letting dimes through, and the quarter tray will collect 50cent coins letting all others through.
inspired to build this thx to this post by IWorkInPixels
thingiverse.com/thing:30571
wish him luck in finishing his mechanism.
45 Degree supports suggested.
Added a OpenSCad File to make your own trays. just open it up set the var and have let it fly!
Stack up the trays from smallest to largest, put the solid tray on the bottom. then shake them.
Trays are labeled for the hole in them not the coin they collect. For example the Dime tray will collect Pennies letting dimes through, and the quarter tray will collect 50cent coins letting all others through.
inspired to build this thx to this post by IWorkInPixels
thingiverse.com/thing:30571
wish him luck in finishing his mechanism.
You must be logged in to post a comment.
License
Coin Sorting Trays by maxumx is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from maxumx
More from Organization
Hello,
I am with the MAKE Magazine photo department. In our upcoming special issue on 3D printing we would like to feature your coin sorter creation in a useful prints section. Can you supply me with high resolution images suitable for print? Please respond as soon as possible to the email address below.
Thanks,
Gunther Kirsch
gkirsch(at)oreilly.com
Makezine.com
yup yup can do.