9v battery clip with switch hole
22
Likes
236
Downloads
2041
Views
Published on September 17, 2012
Derived from
low profile 9v battery sleeve
by agwn
Description
A derivative of agwn's sleeve, but with an extra box on the side that's a press fit for a small slider switch.
Instructions
There is a small quadrant shaped hole through which you poke the positive lead from a battery clip. Cut the red wire and solder it across the switch and pass the black wire through the round hole. Twist the wires together.
The switch is a common or garden variety I had lying around, but it's a nice snug fit and needs no glue.
The switch is a common or garden variety I had lying around, but it's a nice snug fit and needs no glue.
License
9v battery clip with switch hole by pintokitkat is licensed under the Attribution - Share Alike - Creative Commons license.
More from pintokitkat
More from Electronics
You must be logged in to post a comment.