Motor Clamp Plate
3
Likes
112
Downloads
594
Views
Published on September 17, 2012
Description
This object is an improved motor clamp plate for the Replicator Extruder. This upgraded part has a stop to prevent the filement guide tube collets from sliding down and out of position.
Instructions
I uses a scale factor of 1.008 to compensate for thermal shrinkage.
I built this part out of ABS plastic and used a 20% infill.
Once built, I popped the tubing collets out of the original OEM part and pressed them into my new part. Make sure you put the solid ring end UP (see finished picture).
I built this part out of ABS plastic and used a 20% infill.
Once built, I popped the tubing collets out of the original OEM part and pressed them into my new part. Make sure you put the solid ring end UP (see finished picture).
License
Motor Clamp Plate by DDStarkey is licensed under the Attribution - Share Alike - Creative Commons license.
More from DDStarkey
More from 3D Printer Parts
You must be logged in to post a comment.