Dog Fetch Thing
1
Likes
423
Downloads
1057
Views
Published on September 19, 2012
Description
I designed this as a fetch object. It has a really big bridge so it was ideal to test slicer same material support.
The OpenScad file is parameric so edit the file for your dog (large breed or small breed)
The OpenScad file is parameric so edit the file for your dog (large breed or small breed)
Instructions
I printed this in pla with 4 shells (needs to be relatively bite proof) and with 35% infill.
Will post later how well this holds up when things get bitten....
edit: the file names are acually wrong: the 5x9 block is actually 11 cm long because the bar is not through the end block. the 7x12 is actually 14.5cm long. Perhaps there will be a version2..
Will post later how well this holds up when things get bitten....
edit: the file names are acually wrong: the 5x9 block is actually 11 cm long because the bar is not through the end block. the 7x12 is actually 14.5cm long. Perhaps there will be a version2..
License
Dog Fetch Thing by bitflusher is licensed under the Attribution - Share Alike - Creative Commons license.
More from bitflusher
More from Pets
You must be logged in to post a comment.