Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
DLG wing
9
Likes
979
Downloads
1898
Views
Published on September 21, 2012
Description
Hi
This is my project of a DLG wing being able to be 3D printed.
It is not being printed yet but it will be during the next months. Due to the limited space in a 3D printer it is sized a little above 60cm.
This is my project of a DLG wing being able to be 3D printed.
It is not being printed yet but it will be during the next months. Due to the limited space in a 3D printer it is sized a little above 60cm.
Instructions
20th September 2012:
It is designed to be printable at fabberhouse.de. Therefore the size is adjusted to their printer.
Instruction:
The wings should be sticked together with tubes and being attached with glue.
The centerplate (Platte.stl) is far much bigger than for a 3D Printer. Maybe someone of the community will prepare it as an dwg or eps for a cut service like formulor.de. The "Platte.stl" should be cut out of 0.5mm carbon composite material.
Pictures will follow
It is designed to be printable at fabberhouse.de. Therefore the size is adjusted to their printer.
Instruction:
The wings should be sticked together with tubes and being attached with glue.
The centerplate (Platte.stl) is far much bigger than for a 3D Printer. Maybe someone of the community will prepare it as an dwg or eps for a cut service like formulor.de. The "Platte.stl" should be cut out of 0.5mm carbon composite material.
Pictures will follow
You must be logged in to post a comment.
License
More from R/C Vehicles
Nice!
I hope it works out well.